Operating instructions

6.
6.
7.
1. Place your spool of thread on the “thread stand” mounted to
the rear of your machines table top. Normally located on the
right hand rear corner of the sewing machines table top.
2. Pull some thread off the spool and thread it though the eyelet
directly over the spool on the upper horizontal lever of the
thread stand.
3. Pass the thread directly through the first thread guide
#
(A)
Pull the thread over the top of the tension disks in a clockwise
fashion and make certain that the thread slips between the two
tension disks of the upper auxiliary tension assembly
#
(B).
4. Then place the thread back through the thread guide
#
(A).
5. Pull enough thread down and pass it through the middle
thread wire guide
#
(C).
6. Wind the thread in a counter-clockwise direction around the
main thread tension roller
#
(D) two complete revolutions and
again back through the same thread guide
#
(C).
7. Then, pass the thread through the check spring
#
(E) , located
slightly to the right of the main tension
#
(C).
8. Pull additional thread up and pass it through the eyelet of the
“Take-up” lever
#
(F) from the left side to the right side.
9. Then pull more thread down and pass the thread through the
mid thread guide
#
(G) to the left side of the screw.
10. Continue through the lower casting thread guide
#
(H).
11. Then through the Needle Bar thread guide
#
(I).
12. Lastly, pass the thread through the eye of the needle from the
left side of the needle to the right side of the needle towards
the handwheel. About 7 or 8 inches of thread should extend
beyond the needle.
Make one counter-clockwise revolution of the handwheel and pick
up the bobbin thread above the needle plate.
Please Hold the Bobbin and Needle Thread taughtly in one
hand while beginning to stitch the first two or three stitches.
Then release and trim the excess thread.
a
r
-
1. Pull approximately 3 to 4 inches of thread off the bobbin
and insert the new bobbin into the bobbin case so that
when turning the bobbin turns counter-clockwise.
2. Pass the thread through the slot
#
(A) of the bobbin case
and pull the thread until the thread passes under the
bobbin thread tension adjusting spring and rests in the
groove as pictured.
3. Leave at least 3to 5 inches of thread remaining and
hanging out beyond the bobbin case.
4. Turn the handwheel counter-clockwise, with the needle
threaded one revolution, and the bobbin thread will be
pulled up through the needle plate.
F.
(See Back Page for Greater Detail)
A.
B.
E.
G.
C.
D.
H.
I.
F.
6.