User`s guide

Using the Projector

Blank

Press this button to display a blank screen instead of the current

image.

Using the On-Screen Menus

The projector

has menus that allow you to make image adjust-

ments and change a variety of settings.

NOTE: Some menu items may be

grayed out (dimmed) at certain

times. This indicates the item is

not applicable to your setup or the

item is not enabled until another

selection is made.

To open the on-screen menus, press the Menu button on the

keypad or remote. This displays the

Basic menu and changes the

Keystone and Vol u me buttons on the keypad to menu navigation

buttons. Press the down arrow button

to move the cursor down

and press the up arrow

button to move the cursor up. The

selected menu is highlighted.

FIGURE 15

On-screen menu

To change a menu setting, use the up and down arrow buttons to

move the cursor up and down to the item you want to change

(the selected item is highlighted), then press the

Select button.

Use the arrows to adjust the setting or to turn a setting on or off.

Press

Select when you are done.

To access a sub-menu, highlight it and press

Select. To navigate

back to the previous menu, highlight the arrow at the top of the

menu and press

Select.

Use the up and down arrows to move to another setting. When

you have completed your adjustments, press

Menu to close the

menus.

M2+.book Page 20 Thursday, April 8, 2004 8:10 AM

Downloaded From projector-manual.com ASK Manuals