Use and Care Manual

adhesive. Use a high-quality construction adhesive. Be sure to allow the adhesive 24 hours to set-up. See below
for additional information. Our recommended adhesives are Loctite® PL Premium®, Loctite® PL Premium
Advanced®, LePage® PL Premium® (Canada). Carefully read and follow manufacturer’s directions for the
adhesive.
What do I do if my substrate is bumpy or uneven and a tile pops off?
Occasionally, even after properly preparing the substrate, the surface can still have bows, high spots, ridges or
uneven areas. One way to test the area of the substrate where the tile is to be applied is to place a tile (with the
back liner unpeeled) on the area to see if it “rocks” or if it has a solid, flat foundation. If proper adhesion is
difficult or impossible, a tube adhesive can be applied to the back of the tile to allow good adhesion. Be sure to
remove the release film on the back of each tile before applying additional adhesive. Apply no more than about
five pea-sized dots of adhesive to the back of a full tile. Keep the adhesive a half-inch from the edges. Press the
tiles into place. If adhesive squeezes out around the tiles, be sure to wipe it off before it dries.
What are the recommended tube adhesives that can be used if a tile pops up?
Use a 100% polyurethane (tube) adhesive, such as Loctite® PL Premium®, Loctite® PL Premium Advanced®,
LePage® PL Premium® (Canada). Carefully read and follow manufacturer’s directions for the adhesive.
What are the reasons a tile may fall off?
Improper substrate preparation such as a substrate that is not clean, flat, smooth, dry and free of dust, wax,
soap scum and grease. Or, bumpy, wavy surfaces may cause tiles to fall off.
Can grout be used when working with Aspect tiles?
A sand-less grout can be used. A grout containing sand is not recommended as the grout may scratch the
surface of the tile in the cleanup process. If you want a grout-line look, colored or white silicone caulking will
have the same effect and is easier to apply and at the same time providing a water-tight seal. Be sure to remove
excess caulk or grout before it dries.
Can Aspect be exposed to UV Rays and outside elements?
Yes, Aspect warrants that the product will not under normal atmospheric conditions (which excludes corrosive
or aggressive atmospheres such as those contaminated with chemical fumes or salt spray) chip, crack, check, or
peel for a period of (5) five years from date of installation.
Can Aspect be exposed to heat?
Aspect has a heat index of 170 degrees (F) without causing any damage to the tile or panel. Refer to your stove
(or other heat source) manufacturer for specific information.