User manual

26
Use of DiSEqC motor
• Press MENU on your remote control.
• Select INSTALLATION (CD) Press OK to confirm.
• Select ANTENNAS AND SATELLITES PARAMETERS (CD). Press OK to confirm.
• Select INSTALLATION TYPE press CH+/CH- to choose <<MOTORIZED>> PressOK to confirm and
go to the next step.
• Press CH+/CH- to choose the LNB type. Press OK to confirm.
• Use (CD) to select and access the following options and modify the corresponding parameters if needed.
- POINTING
- SATELLITES ACTIVATION
- LIMITS CALCULATION
- RESET AND CENTERING
- SAVE AND QUIT
LIMITS CALCULATION
It is highly necessary and recommended to set the limits of your motor in order to avoid any deterioration of
your antenna and motor. Make sure that no physcal obstacles can interrupt the complete East/West rotation
of the antenna(+60/-60 ).
We strongly recommend, that your motorized system be installed by a qualified satellite engineer.
NB: If your motor does not require setting of limits or if the limits are already set, refer to chapter 4.2.2.
• Select LIMITS CALCULATION (CD) and then press OK to confirm.
• Select NO (F E) if you do not wish to activate the limits, and then press OK.
• Press OK to set the EAST LIMIT and then press the EAST key(red) until you reach the desired limit.
Press OK to confirm.
• Press OK to set the WEST LIMIT and then press the WEST key(blue) until you reach the desired limit.
Perss OK to confirm.
• Press ESC to return to the previous menu and save the new parameters.
RESET AND CENTERING
WARNING !!!!
Only a qualified satellite TV installation engineer can proceed with the following operations. Any misuse of
these functions may result in the damage of your motor.
The centering function allows you to set the motor on a new 0˚ satellite position or to go back to the factory
preset values.
• Move to RESET AND CENTERING using (CD) and then press OK.
• Select CENTERING (CD) if you want to adjust and set the motor to the 0˚ satellite position, then press
OK to confirm.
• Select AUTOMATIC RESET(CD) if you want to adjust and set the motor to the 0˚ motor positionand
reprogram the usual satellites positions. Then press OK to confirm.
• Select MANUAL RESET (CD) if you want to adjust your motor manually to the 0˚ motor position, then
press OK.
• Press EAST/WESTkeys, until you reach the desired position, then press OK to confirm the new 0˚ motor
position.
• Press ESC to save the modifications and go back to the previous menu.