User manual

28
B-Save a satellite position
• When the aiming to a single satellite needs to be modified and saved separately, without affecting the
other satellites in memory then go to SAVE CURRENT SATELLITE POSITION and press OK.
NB: All other satellite positions will not be modified.
C-Quitting without saving
• When proceeding with a check adjustment on an already saved position, go to QUIT WITHOUT SAVING
and press OK.
If you selected another satellite (press OK on (2) ) you must refer to (1) of the same paragraph to set another
pointing position.
If in the paaragraph(3) you selected ESC, you only need to select the satellites from which you want to receive
channels.
• Move to SATELLITES ACTIVATION (CD) and then press OK.
Move within the list of satellites using (CD) to select the desired satellites and press CH+/CH- to confirm
your choice (marked YES). All satellite marked “YES” will be used during channel scanning.
• Press OK to confirm all the selected satellites.
• Move to SAVE AND QUIT then press OK to confirm all previous settings.
5.3 INSTALLATION IN IF TO IF MODE (Collective installation)
• Press MENU.
• Select INSTALLATION (CD) and then press OK.
• Select ANTENNAS AND SATELLITES PARAMETERS and then press OK.
• Move to INSTALLATION TYPE and press CH+/CH- <<SMATV IF-IF TYPE>>.
• Move to LNB POWER SUPPLY and press CH+/CH- to select YES or NO depending on your installation
settings (select NO if your LNB is externally powered).
• Press OK.
From now on you can proceed with automatic installation.
6. AUTOMATIC CHANNELS INSTALLATION
6.1 Symbol rate update
• Press MENU on the remote control.
• Select INSTALLATION (CD) and then press OK.
• Select SYMBOL RATE UPDATE (CD) press OK to confirm.
• Select the corresponding satellite (CD).