Assembling & Installation Instructions

ASSEMBLING ＆ INSTALLATION INSTRUCTIONS
W
ARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
ASSEMBLING THE FIXTURE (Fig.2)
1. Shut off the power at the circuit breaker and remove the old
fixture from ceiling, including the old crossbar.
2. Carefully unpack the new fixture and lay all the parts on a clear
surface.
3. Return the arms to suitable position, see Fig.2.
4. Attach the loop (I) to the fixture body (L) by turning it clock wise
until tight.
HANGING THE FIXTURE (Fig.1)
5. Thread the nipple (C) into the loop (F) until snug.
6. Thread the other end of the nipple (C) with the loop attached into
the crossbar (D) until snug.
7. Place lock washer (B) over end of nipple protruding through
crossbar and thread hex nut (A) onto nipple until tight.
8. Take this crossbar assembly and mount to ceiling junction box
with junction box screws (E). Tighten screws securely with
screwdriver.
The junction box is not included.
9. Using proper chain pliers to open one end link of the chain
provided and connect to the fixture loop (I); then close the link.
10. By measuring, determine correct number of links needed for
proper hanging height. Using proper chain pliers disconnect and
discard remaining chain.
11. Lace the fixture wires through the chain.
12. Slip loop collar (H) and the canopy (G) over the chain.
13. Open the other end link of the chain and hang the fixture on the
loop at the ceiling. Close the link.
14. Feed the fixture wires through the loop (F) and nipple (C) and pull
until tight.
CONNECTING THE WIRES (Fig.3)
15. Connect the electrical wire as shown in figure 3, making sure that
all wire connectors are secured. If your outlet has a ground wire
(green or bare copper), connect the fixtures ground wire to it. If the
junction box has no ground wire, attach the bare copper fixture
wire to the green ground screw on the crossbar. Tuck the wire
connections neatly into the ceiling junction box.
COMPLETING THE INSTALLATION (Fig.2)
16. Raise the canopy (G) all the way to the ceiling; then raise the loop
collar (H) and thread into ceiling loop protruding through canopy.
17. Hang the crystals (N) and the crystal (O) to the loop on the fixture
body (L).
18. Place the crystal cup (K) and the tube (J) over the socket of the
fixture body (L).
19. Insert the crystals (M) into the hole of the fixture body (L).
20. Install the light bulbs (not included) in accordance with the
fixture’s specifications: DO NOT EXCEED THE MAXIMUM
WATTAGE RATING! (NE PAS DEPASSER LA PUISSANCE
NOMINALE MAXIMALE!)
Your installation is now complete. Return power to the junction
box and test the fixture.
Fig.1
Fig.2
Fig.3
White or
HOUSE
Black
WIRES
(Hot)
Smooth
FIXTURE
WIRES
Black or
Ribbed
WIRES
FIXTURE
Bare Copper(Ground)
FIXTURE
WIRES
Copper
(Ground)
HOUSE
(Neutral)
WIRES
White
Bare
Green or
WIRES
HOUSE