Assembly and Installation Instructions

ASSEMBLY AND INSTALLATION
INSTRUCTIONS
NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
WARNING:
WARNING:
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
POWER WHILE INSTALLING OR SERVICING THIS FIXTURE.
Hardware Package(inculded):
1. Install bulbs (not included). See relamping label on socket
area or packaging for maximum allowed wattage.
2. Attach the cover onto the fixture Light and tighten it with
rubber pads and bolt nuts.
3. Pull out the source wires from the post. Make wire connections
using wire nuts as follow:
---Connect the hot wire (usually black insulation) from the fixture to
the black wire from the post
---Connect the neutral wire (usually white insulation) from the fixture to
the white wire from the post
---Attach the fixture grounding wire (usually green insulation or
bare wire) to the grounding wire from the post.
Carefully put the wires back into the post.
4. Place the fitter on the post, then secure it with the fitter screws.
Wire Nut (B)
Fitter Screw (A)
Bulb Type A
Max. 100W
(not included)
Cover
Bolt Nut
Threaded Pipe
Fitter
Fixture Light
Rubber Pad
Grounding Wire
Fixture Wire
Wire Nut (B)
Post
Fitter Screw(A)
Wire Nut (B)
Fitter Screw (A)
A
B
A: 9-1/2”
B: 19-1/2”
Spare Parts List:
Turn off the power at fuse or circuit box
Installation Steps
Turn on the power at fuse or circuit box
The following parts are available for re-order if damaged or missing.
Mounting Hardware