Installation Instruction

ManualsBrandsAstoria Grand ManualsCeiling LightsPerot 6-Light Shaded Classic / Traditional Chandelier

INSTALLATION INSTRUCTION

WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER .

MOUNTING THE FIXTURE (Fig.1)

1. Shut off the power at the circuit breaker box.

Remove old fixture and all hardware from

Junction Box.

2. Carefully unpack your new fixture and lay out all

the parts on a clear area. Take care not to lose

any small parts necessary for installation.

3. Thread the two Studs (A) about 1/4 ” into the

pre-drilled holes in the Crossbar spaced the same

distance apart as the holes in the canopy (B).

4. Attach the Crossbar to the Junction Box with the

two Junction Box Screws as shown. The side of

the Crossbar marked "GND" must face out.

5. While holding the column assembly towards the

ceiling, connect the electrical wires as Shown in

Fig.2, making sure that all wire nuts are secured.

You

may have to wrap the connections with

electrical tape. If your outlet has a ground wire

(green or bare copper) , connect the fixture

ground wire to it . Otherwise connect fixture

’

ground wire directly to the Crossbar with the

green screw provided. After wires are connected,

tuck them carefully inside the Junction Box.

6 . Attach the tube (E) to top of the fixture body (M) and

lock it with the loop (D) until tight.

7. Attach the finial base (O) to the bottom of the fixture

body (M) and lock it with the finial (P).

8. Hook the end of chain (F) to the hook on the top

column and the loop on the iron frame.

9. Place the socket sleeve (L)and the harp(J) over the

socket of the fixture body(M),then lock it securely with

the check ring (K) .Install the light bulb and put the

glass shade(I)on to the harp(J),then screw the

finial(H)onto the glass shade(I). NOTE:

NOTE:

NOTE: DO

DO NOT

NOT

EXCEED

EXCEED THE

THE

THE SPECIFIED

SPECIFIED

SPECIFIED W ATTAGE!

W ATTAGE!

10. Adsorb the magnet of crystal (G) to the center of the

finial (H).

11. Then cover the junction box with the canopy ( B ) ,

a ligning the s crew of mounting plate with the hole of

canopy and lock it with brass ball (C) .

12. Attach the crystal (N) to the fixture body (B), the

fixture body (M) and the finial (P).

Your installation is now complete. Return power to the

junction box and test the fixture.

Fig. 1

Fig. 2

Listed

Summary of content (1 pages)

PAGE 1
INSTALLATION INSTRUCTION WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER . MOUNTING THE FIXTURE (Fig.1) Fig.1 1. Shut off the power at the circuit breaker box. Remove old fixture and all hardware from Junction Box. 2. Carefully unpack your new fixture and lay out all the parts on a clear area. Take care not to lose any small parts necessary for installation. 3. Thread the two Studs (A) about 1/4”into the pre-drilled holes in the Crossbar spaced the same distance apart as the holes in the canopy (B).