User manual
Spin Up Device [Disabled]
Allow you to enable/disable the spin up device feature. Conguration options: [Disabled]
[Enabled]
SATA Device Type [Hard Disk Drive]
Allow you to identify the installed SATA device type. Conguration options: [Hard Disk Drive]
[Solid State Drive]
Typology [Unknown]
This item allows you to identify the SATA topology. Conguration options: [Unknown] [M2]
[Direct Connect] [ISATA] [Flex] [Optical Disk Drive]
Device Sleep [Disabled]
This item allows you to enable or disable device sleep. Conguration options: [Disabled]
[Enabled]
SATA DEVSLEP Idle Timeout Config [Disabled]
This item allows you to enable or disable SATA DTIO Conguration. Conguration options:
[Disabled] [Enabled]
2.6.6 USB Configuration
The items in this menu allow you to change the USB‑related features.
The USB Devices item shows the auto‑detected values. If no USB device is detected, the
item shows None.
Legacy USB Support [Enabled]
[Enabled] Your system supports the USB devices in legacy operating systems.
[Disabled] Your USB devices can be used for BIOS setup only and cannot be
recognized in the boot devices list.
[Auto] Your system automatically detects the presence of USB devices at startup.
If any USB devices are detected, the legacy USB support is enabled.
XHCI Hand-off [Disabled]
[Enabled] Enables the support for operating systems without an XHCI hand‑off
feature.
[Disabled] Disables the XHCI Hand‑off support.
USB single port control
The subitems in this menu allow you to set the USB Port Disable Override features.
USB3_1~8 [Enabled]
Allows you to enable or disable the USB3.0 ports individually. Conguration options:
[Disabled] [Enabled]
USB9~14 [Enabled]
Allows you to enable or disable the USB2.0 ports individually. Conguration options:
[Disabled] [Enabled]
2‑34 Chapter 2: Getting started