User's Manual

2‑20 Chapter 2: BIOS information
Front Panel Type [HD]
Allows you to set the front panel audio connector (AAFP) mode to legacy AC’97 or high‑
denition audio depending on the audio standard that the front panel audio module supports.
[HD] Sets the front panel audio connector (AAFP) mode to high denition audio.
[AC97] Sets the front panel audio connector (AAFP) mode to legacy AC’97.
SPDIF Out Type [SPDIF]
[SPDIF] Sets to [SPDIF] for SPDIF audio output.
[HDMI] Sets to [HDMI] for HDMI audio output.
Realtek LAN Controller [Enabled]
[Enabled] Enables the Realtek LAN controller.
[Disabled] Disables the controller.
Realtek PXE OPROM [Disabled]
This item appears only when you set the Realtek LAN Controller item to [Enabled] and
allows you to enable or disable the Rom of the Realtek LAN controller. Conguration options:
[Enabled] [Disabled]
Charging USB devices in Power State S5 [Disabled]
[Enabled] Charges USB devices even in when the system is in Power State S5.
[Disabled] Disables this function.
Serial Port Configuration
The sub‑items in this menu allow you to set the serial port conguration.
Serial Port [Enabled]
Allows you to enable or disable the serial port (COM).Conguration options: [Enabled]
[Disabled]
Change Settings [Auto]
This item appears only when you set the Serial Port to [Enabled] and allows you to
select the Serial Port base address. Conguration options: [Auto] [IO=3F8h; IRQ=4]
[IO=2F8h; IRQ=3] [IO=3E8h; IRQ=4] [IO=2E8h; IRQ=3]
2.6.6 APM
Deep S4 [Disabled]
When the system enters the S4 state and this item is set to [Enabled], the system will be put
to deep S4 sleep state to reduce power consumption. The system in deep S4 state can only
be woken up via the power button. Conguration options: [Disabled] [Enabled]
Restore AC Power Loss [Power Off]
[Power On] The system goes into on state after an AC power loss.
[Power Off] The system goes into off state after an AC power loss.
[Last State] The system goes into either off or on state, whatever the system state was
before the AC power loss.