User Guide

Chapter 2: Hardware information

8) IDE Activity LED (2-pin IDE_LED)

This connector supplies power to the cabinet’s IDE activity LED. Read and

write activity by devices connected to the Primary or Secondary IDE

connectors cause the IDE LED to light up.

9) Floppy Disk Drive Connector (34-1 pin FLOPPY)

This connector supports the provided floppy drive ribbon cable. After

connecting the single end to the board, connect the two plugs on the other

end to the floppy drives. (Pin 5 is removed to prevent inserting in the

wrong orientation when using ribbon cables with pin 5 plugged).

A7S333

A7S333 IDE Activity LED

TIP: If the case-mounted LED does not

light, try reversing the 2-pin plug.

IDE_LED

A7S333

NOTE: Orient the red markings on

the floppy ribbon cable to PIN 1.

A7S333 Floppy Disk Drive Connector

PIN 1

FLOPPY