User's Manual

ASUS A8N-SLI PremiumASUS A8N-SLI Premium
ASUS A8N-SLI PremiumASUS A8N-SLI Premium
ASUS A8N-SLI Premium
2-232-23
2-232-23
2-23
4.4.
4.4.
4.
Serial ATA RAID connectors (7-pin SATA_RAID1,Serial ATA RAID connectors (7-pin SATA_RAID1,
Serial ATA RAID connectors (7-pin SATA_RAID1,Serial ATA RAID connectors (7-pin SATA_RAID1,
Serial ATA RAID connectors (7-pin SATA_RAID1,
SATA_RAID2, SATA_RAID3, SATA_RAID4)SATA_RAID2, SATA_RAID3, SATA_RAID4)
SATA_RAID2, SATA_RAID3, SATA_RAID4)SATA_RAID2, SATA_RAID3, SATA_RAID4)
SATA_RAID2, SATA_RAID3, SATA_RAID4)
Supported by the Silicon Image
®
Sil3114 RAID controller, these
connectors are for Serial ATA signal cables. These connectors support
up to four Serial ATA hard disk drives that can be configured as a disk
array through the onboard Silicon Image Sil3114 SATA RAID
controller. Refer to Chapter 5 for details on how to set up Serial ATA
RAID configurations.
• Before creating a RAID configuration, make sure that you have
connected the Serial ATA cables to these connectors and have
installed the Serial ATA hard disks drives; otherwise, you cannot
enter the Silicon Image RAID utility and Serial ATA BIOS setup during
POST.
• See Appendix for instructions on how to install the Serial ATA
extension module.
By default, the RAID function of these connectors are enabled. Disable
the
Silicon SATA controllerSilicon SATA controller
Silicon SATA controllerSilicon SATA controller
Silicon SATA controller item in the BIOS, if you are not
configuring a set with these connectors. See section “4.4.3 Onboard
Devices Configuration” on page 4-24 for details.
A8N-SLI PREMIUM
®
A8N-SLI PREMIUM SATA RAID connectors
SATA_RAID2
GND
RSATA_TXP2
RSATA_TXN2
GND
RSATA_RXP2
RSATA_RXN2
GND
SATA_RAID4
GND
RSATA_TXP4
RSATA_TXN4
GND
RSATA_RXP4
RSATA_RXN4
GND
SATA_RAID1
GND
RSATA_TXP1
RSATA_TXN1
GND
RSATA_RXP1
RSATA_RXN1
GND
SATA_RAID3
GND
RSATA_TXP3
RSATA_TXN3
GND
RSATA_RXP3
RSATA_RXN3
GND