Instruction Manual

User’s Manual 2-19
2.6.1 Placing an ATA133 IDE hard disk drive to tray
The following steps describe the installation of a hard disk drive into the
drive tray.
1. Place the hard disk tray on a flat
clean surface. Prepare Philips
(cross) screwdriver.
3. Replace the rear bracket and
fasten with screws.
Rear bracket
Middle bracket
2. Remove middle bracket. To
release from pin, unscrew rear
bracket and slowly detach middle
bracket. Take caution in handling
the drive tray, the plastic drive
tray rail may break.
Drive tray rail