Owner manual

2-26 Chapter 2: Hardware information
• System Power LED Lead (3-1 pin PLED)
This 3-1 pin connector connects to the system power LED. The LED
lights up when you turn on the system power, and blinks when the
system is in sleep mode.
• System Message LED Lead (2-pin MLED)
This 2-pin connector is for the system message LED that indicates
receipt of messages from a fax/modem. The normal status for this LED
is OFF, when there is no incoming data signal. The LED blinks when
data is received. The system message LED feature requires an ACPI
OS and driver support.
• System Warning Speaker Lead (4-pin SPEAKER)
This 4-pin connector is for a chassis-mounted speaker.
• ATX Power Switch / Soft-Off Switch Lead (2-pin PWR)
This lead connects a switch that controls the system power. Pressing
the power switch turns the system between ON and SLEEP, or ON and
SOFT OFF, depending on the BIOS or OS settings. Pressing the
power switch while in the ON mode for more than 4 seconds turns the
system OFF.
• Reset Switch Lead (2-pin RESET)
This lead connects to the case-mounted reset switch for rebooting the
system without turning off the system power.
• System Management Interrupt Lead (2-pin SMI)
This lead connects to the case-mounted suspend switch, and allows
you to manually place the system into “Suspend Mode” or “Green
Mode” where system activity is decreased to save electricity and
expand the life of system components.
• Keylock Lead (2-pin KEYLOCK)
This lead connects to a chassis-mounted switch to allow use of the
keyboard lock feature.