Service manual

7 - 14 Genie GS-1530 & Genie GS-1930 Part No. 39528
Service Manual - First Edition
Section 7 - Repair Procedures
SCISSOR COMPONENTS
44 Attach the overhead crane to the number 1 inner
arm (index #10). Do not lift it.
45 Remove the pin retaining fasteners from the
number 1 pivot pin at the ground controls side.
Use a slide hammer to remove the pin.
46 Repeat step 45 for the battery pack side.
Remove the number 1 inner arm (index #10)
from the machine.
Bodily injury hazard. The number 1
inner arm (index #10) may become
unbalanced and fall if not properly
supported when the pins are
removed.
How to Replace the Scissor Arm
Wear Pads
(before serial number 632)
1 Remove the platform. See 2-1, How to Remove
the Platform.
2 Carefully slide the forks from a forklift under the
scissor arms at the non-steer end of the
machine.
3 Attach a strap from the scissor arms to the
carriage on the forklift for support.
4 Remove the pin retaining fasteners from the
number 1 inner arm pivot pins. Use a slide
hammer to remove the pins.
5 Remove the fasteners from the level sensor
box. Remove the box.
6 Remove the fasteners from the level sensor.
Remove the level sensor.
7 Slide the scissor assembly towards the non-
steer end of the machine approximately 18
inches (45.7 cm).
8 Remove the mounting fasteners from the
stationary wear pads on the platform and at the
steer end of the chassis.
Note the position of the old wear
pads before they are removed so
when the new ones are installed
they will be in the correct position.
9 Install the new wear pads with new fasteners.
10 Slide the movable wear pads off of the number 3
inner arm (index #3) and the number 1 outer arm
(index #16). Install the new wear pads.
11 Re-assemble machine in reverse order in which
it was disassembled.