Service manual

Part No. 39528 Genie GS-1530 & Genie GS-1930 7 - 9
Service Manual - First Edition Section 7 - Repair Procedures
PLATFORM COMPONENTS
2-2
Platform Extension
How to Remove the
Platform Extension
1 Lower the platform to the stowed position.
2 Extend the platform approximately 3 feet (1 m).
3 Remove the platform controls from the platform
and lay them off to the side of the machine.
4 Support the platform extension with a forklift at
the steer end. Do not lift it.
5 Attach a strap from the platform extension
railings to the carriage on the forklift to help
support the platform extension.
6 Remove the mounting fasteners from all four of
the platform extension roller supports.
7 Remove the roller supports and the roller
wheels.
8 Carefully slide the platform extension out from
the platform and place it on a structure capable
of supporting it.
How to Replace the Platform
Extension Wear Pads
1 Remove the Platform Extension. See 2-2, How
to Remove the Platform Extension.
2 Drill out the rivets which hold the wear pads in
place.
3 Install the new wear pad using new rivets.
When installing new rivets, make
sure the rivet heads are not above
the surface of the wear pad.