Specifications

ASUS P5KC 2-33
4. JMicron JMB363
®
Serial ATA RAID connector (7-pin SATA_E2)
This connector is for a Serial ATA signal cable that supports a Serial ATA hard
disk drive. To congure RAID 0, RAID 1, or JBOD, install an internal Serial
ATA hard disk drive to this connector and an external Serial ATA drive to the
external SATA port.
The JMicron controller mode item in the BIOS is set to [IDE] by default. Setting
this item to [RAID] allows you to use the connectors to build a RAID set. See
section 5.4.3 JMicron
®
RAID Conguration for details. Setting this item to
[AHCI] supports Native Command Queuing (NCQ) function. See section 4.4.5
Onboard Devices Conguration for details.
Before creating a RAID set using Serial ATA hard disks, make sure that you
have connected the Serial ATA signal cables and installed Serial ATA hard disk
drives; otherwise, you cannot enter the JMicron
®
JMB363 RAID utility and SATA
BIOS setup during POST.
P5KC
®
P5KC SATA connector
SATA_E2
GND
RSATA_TXP2
RSATA_TXN2
GND
RSATA_RXP2
RSATA_RXN2
GND