Owner manual

ASUS CUBX User’s Manual 19

3. HARDWARE SETUP

3. H/W SETUP

Motherboard Settings

2) Voltage I/O Setting (VIO)

This jumper allows you to select the voltage supplied to the DRAM, chipset,

AGP, and PCI. The default setting of 3.45Volt should be used unless processor

overclocking requires a higher voltage (3.60Volt).

Setting VIO

3.45Volt [1-2] (default)

3.60Volt [2-3]

CUBX

CUBX Input/Output Voltage Setting

VIO

3.45 Volt

(Default)

3.60 Volt

WARNING! Using a higher voltage may help when overclocking but may result

in the shortening of your computer component’s life. It is highly recommended

that you leave this setting on its default.

3) AGP Bus Frequency Setting (DSW Switch 6)

This option sets the frequency ratio between the AGP bus frequency and the DRAM

(CPU bus) frequency. The default sets the AGP bus frequency to be 2/3 of the

DRAM frequency. When the CPU/DRAM frequency is set to 66MHz, set this

switch to [ON]. See the processor table on the next page.

Setting DSW Switch 6

DRAM Freq. x 2/3 [OFF] (default)

DRAM Freq. x 1 [ON]

CUBX AGP Bus Frequency Setting

DRAM Freq. x2/3DRAM Freq. x1

123456 78910

CUBX