User's Manual

50
DSL-N12U Apêndices
FCC/Canada Radiation Exposure Statement
This equipment complies with FCC/Canada radiation exposure limits set forth for an
uncontrolled environment.
This equipment should be installed and operated with minimum 20cm between the
radiator and your body.
IC Warning Statement
This device had been designed to operate with the antennas for a maximum gain 5dBi,
antenna type: dipole.
Antennas not described as above are strictly prohibited for use with this device.
This device complies with RSS-210 of the Industry Canada Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful interference, and (2)
This device must accept any interference received, including interference that may cause
undesired operation.
Ce dispositif est conforme à la norme CNR-210 d’Industrie Canada applicable aux
appareils radio exempts de licence. Son fonctionnement est sujet aux deux conditions
suivantes: (1) le dispositif ne doit pas produire de brouillage préjudiciable, et (2) ce
dispositif doit accepter tout brouillage reçu, y compris un brouillage susceptible de
provoquer un fonctionnement indésirable.
NOTICES:
This equipment meets the applicable Industry Canada Terminal Equipment Technical
Specications. This is conrmed by the registration number. The abbreviation, IC,
before the registration number signies that registration was performed based on a
Declaration of Conformity indicating that Industry Canada technical specications
were met. It does not imply that Industry Canada approved the equipment.
The Ringer Equivalence Number (REN) for this terminal equipment is 01. The REN
assigned to each terminal equipment provides an indication of the maximum
number of terminals allowed to be connected to a telephone interface. The
termination on an interface may consist of any combination of devices subject
only to the requirement that the sum of the Ringer Equivalence Numbers of all the
devices does not exceed ve.
AVIS :
Le présent matériel est conforme aux spécications techniques d’Industrie
Canadaapplicables au matériel terminal. Cette conformité est conrmée par le
numérod’enregistrement. Le sigle IC, placé devant le numéro d’enregistrement,
signie quel’enregistrement s’est eectué conformément à une déclaration de
conformité et indique queles spécications techniques d’Industrie Canada ont été
respectées. Il nimplique pasqu’Industrie Canada a approuvé le matériel.
L’indice d’équivalence de la sonnerie (IES) du présent matériel est de 01.
L’IESassigné à chaque dispositif terminal indique le nombre maximal de terminaux
qui peuvent êtreraccordés à une interface téléphonique. La terminaison d’une
interface peut consister en unecombinaison quelconque