Motherboard TRL-DLS Owner manual

ASUS TRL-DLS User’s Manual60

4. BIOS SETUP

Boot Menu

Plug & Play O/S [No]

This field allows you to use a Plug-and-Play (PnP) operating system to configure

the PCI bus slots instead of using the BIOS. When [Yes] is selected, interrupts may

be reassigned by the OS. When a non-PnP OS is installed or you want to prevent

reassigning of interrupt settings, select the default setting of [No]. Configuration

options: [No] [Yes]

Reset Configuration Data [No]

The Extended System Configuration Data (ESCD) contain information about non-

PnP devices. It also holds the complete record of how the system was configured the

last time it was booted. Select [Yes] if you want to clear these data during the Power-

On-Self-Test (POST). Configuration options: [No] [Yes]

MPS 1.4 Support [Enabled]

This field allows you to enable or disable the MultiProcessor Specification 1.4 support.

Configuration options: [Disabled] [Enabled]

Quick Power On Self Test [Enabled]

This field speeds up the Power-On-Self Test (POST) routine by skipping retesting a

second, third, and fourth time. Configuration options: [Disabled] [Enabled]

Boot Up Floppy Seek [Enabled]

When enabled, the BIOS seeks the floppy disk drive once during bootup.

Configuration options: [Disabled] [Enabled]