User's Manual

5-48 Chapter 5: Software support
5.4.3 Marvell
®
eSATA RAID congurations
The Marvell
®
88SE6121 external SATA controller allows you to congure RAID 0
and RAID 1 sets on the external SATA hard disk drives, or RAID 0, 1, 5 and 10
set(s) on external port-multiplier devices.
Setting the RAID item in BIOS
You must set the RAID item in the BIOS Setup before you can create a RAID
set(s). To do this:
1. Install two external Serial ATA hard disk drives to the external SATA ports
labeled
ESATA1/2
.
2. Boot up your computer, and press <Del> during POST to enter the BIOS
setup.
3. In the
Advanced
menu, go to
Onboard Devices Conguration
, and enable
both
Marvell 6121/eSATA
and
6121 Boot ROM
.
4. Set the
Marvell 6121/eSATA
item to [RAID].
5. Press <F10> to save the changes and exit.
The RAID BIOS setup screens shown in this section are for reference only, and
may not exactly match the items on your screen.
Select Screen
Select Item
+- Change Option
F1 General Help
F10 Save and Exit
ESC Exit
v02.61 (C)Copyright 1985-2008, American Megatrends, Inc.
Onboard Device Conguraiton
High Denition Audio [Enabled]
OnChip LAN1 [Auto]
OnChip LAN2 [Auto]
LAN Boot ROM [Disabled]
Marvell 6121/eSATA [Legacy Mode]
6121 Boot ROM [Enabled]
Marvell 6320/SAS [Enabled]
6320 Boot ROM [Enabled]
Onboard 1394 [Enabled]
Serial Port1 Address [3F8/IRQ4]
Enable or Disable
High Denition Audio
Controller
BIOS SETUP UTILITY
Advanced