User’s Manual

PE200U Series

3.10 Installing the antennas (optional)

1. Remove the rubber caps from the antenna hole.

2. Prepare the RF connector and cable.

3. Insert the antenna jack end of the RF connector and cable into the

antenna hole from within the chassis outwards.

4. Insert the bundled O-ring to the antenna jack, then secure the

antenna jack using bundled hex screw.

5. Connect the other end of the RF connector and cable to your wireless

card or WWAN card.

6. Repeat steps 1 to 5 to install additional antennas.

You may install antennas to the four (4) antenna holes located on the front

and rear panels. The installed antennas can be connected to a WWAN card

installed in the Mini PCIe/mSATA slot, or to a wireless card installed in the

M.2 Wi-Fi slot.