User`s manual

89
RX3042H User's Manual System Management
10 System Management
This chapter describes the following administrative tasks that you
can perform using the Configuration Manager:
• Configure available system services
• Modify password and configure system settings
• View system information
• Modify system date and time
• Configure SNMP
• Reset system configuration to factory default settings
• Backup and restore system configuration
• Restart system
• Update firmware
10.1 Configure System Services
As shown in Figure 10.1, you can use the System Services
configuration page to enable or disable services supported by the
RX3042H. All services, except DDNS, SNTP, UPnP and RIP, are
all enabled at the factory. To disable or enable individual service,
follow the steps below:
1. Open the System Services configuration page by clicking
Management ->System
Services menu.
2. Click on the corresponding
Enable
or
Disable
radio button to
enable or disable the desired service.
3. Click on
Apply
button to save the changes.
Figure 10.1. System Services Configuration Page