User`s manual

91
RX3042H User's Manual
System Management
new password in the same upper and lower case characters
that you enter here.
3. Click on
Apply
button to save the new password.
10.2.2 Configure System Settings
Follow the steps below to modify system settings:
1. Open the System Administration configuration page, as shown in
Figure 10.2, by clicking the
Router Setup ->Administration
menu.
2. Clone the MAC address for WAN
a) If you had previously registered a specific MAC address with
your ISP for Internet access, check the
Clone WAN MAC
check
box and enter the registered MAC address here.
3. Allow Administration from WAN: check or uncheck the check box
to enable or disable remote management via WAN port.
4. Allow Ping Interface: This option allows user to control access
to the router using ping via the LAN or WAN ports. Check the
respective check box to enable ping from the respective interface.
5. Click on
Apply
button to save the settings.
10.3 Viewing System Information
System Information page displays whenever you log into RX3042H.
You may also click on the Status menu to see the system
information. This page shows information of the overall system
settings.