User`s manual

96
System Management RX3042H User's Manual
1. Open the Log configuration page, as shown in Figure 10.6, by
clicking the
Management ->Log
menu
2. Click
Enable Remote Log
check box to enable remote logging.
3. Enter the syslog server IP address in the
Syslog Server IP
Address
field.
4. Click on
Apply
button to save the settings.
10.6.2 View the System Log
You may open the firewall log page by clicking
Firewall/NAT
->Log
menu to see any logged. Figure 10.7 shows a sample
log. You may click on the
Reload
button at the bottom of the
Log configuration page to see the updated log messages. To
clear the log messages, just click on the
Clear Log
button.
Figure 10.7 Sample Log
10.7 Configuration Management
10.7.1 Restore System Configuration to Factory
Default Settings
At times, you may want to restore system configuration to the
factory default settings to eliminate problems resulted from incorrect
system configuration. Follow the steps below to reset the system
configuration:
1. Open the Factory Default configuration page, as shown in Figure
10.8, by clicking the
Management ->Configuration ->Factory
Default
menu.