User`s manual

RX3042H User's Manual

Quick Start Guide

You should verify that the LEDs are illuminated as indicated in Table 3.1.

Table 3.1 LED Indicators

This LED: ...should be:

POWER Solid green to indicate that the device is turned

on. If this light is not on, check if the AC adapter is

attached to the RX3042H and if it is plugged into a

power source.

LAN LEDs Solid green to indicate that the device can

communicate with your LAN or flashing when the

device is sending or receiving data to/from your

LAN computer(s).

WAN Solid green to indicate that the device has

successfully established a connection with your ISP

or ﬂashing when the device is sending or receiving

data to/from the Internet.

If the LEDs illuminate as expected, the RX3042H is working properly.

3.2 Part 2 — Conﬁguring Your Computers

Part 2 of the Quick Start Guide provides instructions for conﬁguring the

network settings on your computers to work with the RX3042H.

3.2.1 Before you begin

By default, the RX3042H automatically assigns all required network

settings (e.g. IP address, DNS server IP address, default gateway

IP address) to your PCs. You need only to conﬁgure your PCs to

accept the network settings provided by the RX3042H.

Note: In some cases, you may want to configure

network settings manually to some or all of your

computers rather than allow the RX3042H to do so.

See “Assigning static IP addresses to your PCs” in

page 13 for instructions.

• If you have connected your PC via Ethernet to the RX3042H,

follow the instructions that correspond to the operating

system installed on your PC.

3.2.2 Windows® XP PCs: