User`s manual

Router Setup RX3042H User's Manual
28
Table 5.1 LAN Configuration Parameters
Settings Description
Host Name For identification only.
IP Address The LAN IP address of the RX3042H. This IP
address is used by your computers to identify
the RX3042Hʼs LAN port. Note that the public IP
address assigned to you by your ISP is not your
LAN IP address. The public IP address identifies
the WAN port on the RX3042H to the Internet.
Subnet Mask The LAN subnet mask identifies which parts of
the LAN IP Address refer to your network as a
whole and which parts refer specifically to nodes
on the network. Your device is preconfigured with
a default subnet mask of 255.255.255.0.
5.1.3 Configuring the LAN IP Address
Follow these steps to change the default LAN IP address.
1. Open the Connection configuration page, as shown in Figure 5.1
by clicking the
Router Setup -> Connection
menu.
Figure 5.1 Network Setup Configuration- LAN Configuration
2. (Optional) Enter the host name for RX3042H. Note that host
name is used for identification only and is not used for any other
purpose.
3. Enter the LAN IP address and subnet mask for the RX3042H in
the space provided.
4. Proceed to the WAN Configuration section for instructions on
setting up the WAN port if you have not yet done so.