User`s manual

Router Setup RX3042H User's Manual
32
Setting Description
Connect on
Demand
Click on the Enable or Disable radio button to enable
or disable this option.
Status On: PPPoE connection is active.
Off: No PPPoE connection is active.
Connecting: RX3042H is trying to connect to your
ISP using PPPoE connection mode.
Manual
Disconnect/
Connect
Click the Disconnect or Connect button to disconnect
or connect using the PPPoE connection mode.
5.2.2.2 Configuring PPPoE for WAN
Follow the instructions below to configure PPPoE settings:
1. Open the Network Setup configuration page by clicking the
Router Setup -> Connection
menu.
2. Select which WAN port (WAN1/WAN2) to configure for PPPoE
connection mode.
3. Select
PPPoE
from the WAN Connection Mode drop-down list
as shown in Figure 5.3.
4. Select
PPPoE session ID
from the PPPoE session ID drop-
down list. Currently, two sessions are supported for each WAN
port.
5. Enter the service name if required by your ISP.
6. (Optional) Enter the service name and/or AC name if required by
your ISP.
7. (Optional) If your ISP allows you to always obtain the same IP
address for your WAN, enter it in the IP Address field; otherwise,
skip this step.
8. (Optional) Enter the IP addresses for the primary and/or
secondary DNS servers if you want to use your preferred DNS
servers; otherwise, skip this step.
9. (Optional) Change the MTU value if necessary. If you do
not know what value to enter, leave it as is. For dynamic IP