User`s manual

Router Setup

RX3042H User's Manual

5.2.3.1 WAN PPPoE Unnumbered Conﬁguration Parameters

Table 5.3 describes the configuration parameters available for

PPPoE Unnumbered connection mode.

Table 5.3. WAN PPPoE Unnumbered Conﬁguration Parameters

Setting Description

Link Select a port to conﬁgure. Available options are

WAN1, WAN2 or DMZ.

Connection

Mode

Select PPPoE Unnumbered from the connection

mode drop-down list. Traditionally, each network

interface must have a unique IP address. However,

an unnumbered interface does not have to have a

unique IP address. This means that when this option

is selected, the WAN and the LAN use the same IP

address. Network resources are therefore conserved

because fewer network IP addresses are used and

routing table is smaller.

Enable NAPT Check or uncheck this box to enable NAPT for

this connection.

User Name

and Password

Enter the username and password you use to log into

your ISP. (Note: this is different from the information

you used to log into Conﬁguration Manager.)

Service Name Enter the service name provided by your ISP. Service

name is optional but may be required by some ISPs.

AC Name Enter the access concentrator name provided by

your ISP. Access concentrator name is optional

but may be required by some ISPs.

IP Address Enter a static IP address here for the PPPoE

unnumbered connection. This IP address must be

provided by your service provider.

Unnumbered

Network

Address

Enter the network address provided by your ISP.

Primary /

Secondary

DNS Server

IP address of the primary and/or secondary DNS

are optional as PPPoE will automatically detect

the DNS IP addresses conﬁgured at your ISP.

However, if there are other DNS servers you

would rather use, enter the IP addresses here.