User`s manual

RX3042H User's Manual Router Setup
39
9. Click
Apply
to save the settings
5.2.6 PPTP
Some of the service providers require user to login using PPTP
connection.
5.2.6.1 WAN PPTP Configuration Parameters
Table 5.5 describes the configuration parameters available for
PPTP connection mode.
Table 5.5. WAN PPTP Configuration Parameters
Setting Description
Link Select a port to configure. Available options are WAN1,
WAN2 or DMZ.
Connection
Mode
Select PPTP from the connection mode drop-down list.
WAN
Interface IP
Select how WAN IP address is to be configured – static
(manually set the IP address) or dynamic (obtained
automatically from the DHCP server).
Static Choose this connection mode if the WAN IP is a fixed IP
provided by your ISP.
IP Address Enter the WAN IP address provided by your ISP.
Subnet Mask Enter the subnet mask for the WAN IP provided by your ISP.
Gateway
Address
Enter the gateway IP address for the WAN provided by your
ISP.
Dynamic
(DHCP)
Select this connection mode if your WAN IP address is
obtained automatically from your ISPʼs DHCP server.
User
Name and
Password
Enter the username and password you use to log into your
ISP. (Note: this is different from the information you used to
log into Configuration Manager.)
Server IP
Address
Enter the PPTP server IP address provided by your ISP.
MTU You may specify the maximum size of the transmitted packet.
For PPTP, the range of MTU is from 546 to 1460. The default
value is 1460.
MPPE MPPE stands for Microsoft Point-to-Point Encryption
protocol. Check this box, if the packet is to be encrypted w/
this protocol.