User`s manual

DHCP Server Configuration RX3042H User's Manual
44
Follow the instructions below to set up WAN load balancing:
1. Open the Load Balancing configuration page by clicking the
Router Setup ->Load Balance
menu.
2. Select
Auto Mode
in the Load Balance field.
3. Enter the ratio of the traffic amount that you want to distribute
between the two WANs. The allowable value is from 0 to 100%.
The sum of the two numbers is 100%.
4. Select whether you need to enable or disable connectivity
check. If this option is enabled, please also enter the following:
a) Enter the connectivity check interval.
b) (Optional) Enter the connectivity check IP address for WAN1
and/or WAN2.
5. Click
Apply
to save the settings.
5.3.3 Setting Up WAN Line Back Up
Follow the instructions below to set up line backup:
1. Open the Load Balancing configuration page by clicking the
Router Setup ->Load Balance
menu.
2. Select “
Line Backup
” in the Load Balance field.
3. Select whether you need to enable or disable connectivity
check. If this option is enabled, please also enter the following:
a) Enter the connectivity check interval.
b) (Optional) Enter the connectivity check IP address for WAN1
and/or WAN2.
4. Click
Apply
to save the settings.