User`s manual

DHCP Server Conﬁguration

RX3042H User's Manual

6.1.3 Conﬁguring DHCP Server

Note: By default, the RX3042H is configured as a

DHCP server on the LAN side, with a predeﬁned IP

address pool of 192.168.1.100 through 192.168.1.149

(subnet mask 255.255.255.0). To change this range

of addresses, follow the procedures described in this

section.

First, you must configure your PCs to accept DHCP information

assigned by a DHCP server:

1. Open the DHCP Server Conﬁguration page, shown in Figure 6.1,

by clicking Advanced -> DHCP Server menu.

Figure 6.1. DHCP Server Conﬁguration Page

2. Enter the information for the IP Address Pool (Begin/End

Address), Subnet Mask, Lease Time and Default Gateway IP

Address, ﬁelds; others, such as Primary/Secondary DNS Server

IP Address and Primary/Secondary WINS Server IP Address are

optional. However, it is recommended that you enter the primary

DNS server IP address in the space provided. You may enter

the LAN IP or your ISPʼs DNS IP in the primary DNS Server

IP Address field. Table 6.1 describes the DHCP configuration

parameters in detail.