User`s manual

Routing RX3042H User's Manual
54
7.2 Dynamic Routing using RIP (Routing
Information Protocol)
RIP enables routing information exchange between routers; thus,
routes are updated automatically without human intervention.
It is recommended that you enable RIP in the System Services
Configuration Page as shown in Figure 10.1.
Figure 7.1. RIP Configuration Page
7.2.1 RIP Configuration Parameters
The following table defines the available configuration parameters
for static routing configuration.
Table 7.1. Static Route Configuration Parameters
Field Description
Interface
Select an interface through which the routing
information is exchanged. Available options are
LAN, WAN1, WAN2, PPPoE1, PPPoE2, PPPoE3
and PPPoE4.
RIP
Click the “Enable” or “Disable” radio button to
enable or disable “RIP” for the interface selected.
Note that you must enable RIP service first in the
Management / System Services configuration
page first.