User`s manual

Routing RX3042H User's Manual
56
information. Available options are Version 1, Version 2 and Both.
6. Choose whether authentication is required by clicking the
Enable
or
Disable
radio button.
7. (Optional) If authentication is enable, you must also select
authentication mode and the desired authentication key.
8. Click
Apply
to save the settings.
7.3 Static Route
Figure 7.2. Static Route Configuration Page
7.3.1 Static Route Configuration Parameters
The following table defines the available configuration parameters
for static routing configuration.
Table 7.2. Static Route Configuration Parameters
Field Description
Destination
Address
Specifies the IP address of the destination computer or
an entire destination network. It can also be specified
as all zeros to indicate that this route should be used for
all destinations for which no other route is defined (this
is the route that creates the default gateway). Note that
destination IP must be a network ID. The default route uses
a destination IP of 0.0.0.0. Refer to Appendix 11 for an
explanation of network ID.