User`s manual

RX3042H User's Manual Routing
57
Field Description
Subnet
Mask
Indicates which parts of the destination address refer to the
network and which parts refer to a computer on the network.
Refer to Appendix 11, for an explanation of network masks.
The default route uses a 0.0.0.0 for subnet mask.
Gateway
Gateway IP address
Interface
Available option include AUTO, Eth0 (LAN), Eth1 (WAN),
PPPoE:0 (unnumbered), PPPoE:1 (1st PPPoE session),
PPPoE:2 (2nd PPPoE session). These options are
selectable from the drop-down list. If AUTO is selected, the
router will automatically assign an interface to route the
packets based on the gateway IP address.
7.3.2 Adding Static Routes
Figure 7.3. Static Route Configuration
Follow these instructions to add a static route to the routing table.
1. Open the
Static Route
configuration page by clicking the
Advanced ->Static Route
menu.
2. Enter static routes information such as destination IP address,
destination subnet mask, gateway IP address and the interface
in the corresponding fields.
For a description of these fields, refer to Table 7.2. Static
Route Configuration Parameters.
To create a route that defines the default gateway for your
LAN, enter 0.0.0.0 in both the Destination IP Address and
Subnet Mask fields.
3. Click
Add
to add a new route.