User`s manual

RX3042H User's Manual Configuring Firewall
79
Figure 9.8. Self-Access ACL Configuration Example
9.6.2 Modify a Self-Access Rule
To modify a Self-Access rule, follow the instructions below:
1. Open the Self-Access ACL configuration page by clicking
Firewall/NAT ->Self-Access ACL
menu.
2. Click on the icon of the Self-Access rule to be modified in the
Existing Self-Access ACL
table or select the Self-Access ACL
from the
ID
drop-down list.
3. Make desired changes to any or all of the following fields: action,
source/destination IP, service, time and log. Please see Table 9.3
for explanation of these fields.
4. Click on the "
Modifiy
" button to save the changes. The new
settings for this Self-Access rule will then be displayed in the
Existing Self-Access ACL table located at the bottom half of the
Self-Access ACL configuration page.
9.6.3 Delete a Self-Access Rule
To delete a Self-Access rule, click on the icon of the rule to be
deleted.
Example
Figure 9.8 shows a sample self-access ACL configuration to allow
HTTP traffic from any one to RX3042H.