User Manual

4-28
第四章：BIOS 程序設置
4.4.9 WHEA 設置（WHEA Configuration）
Enable or disable Windows
Hardware Error Architecture.
WHEA Support [Enabled]
WHEA Support [Enabled]
允許您開啟或關閉 Windows Hardware Error Architecture 功能。設置值
有：[Disabled] [Enabled]
4.4.10 APM 設置（APM setting）
Restore AC Power Loss [Last State]
若設置為 [Po w er O ff]，則當系統在電源中斷之後電源將進入關閉狀
態。若設置為 [Power On]，當系統在電源中斷之後維持開啟狀態。若設置
為 [Last State]，會將系統設置恢復到電源未中斷之前的狀態。設置值有：
[Power Off] [Power On] [Last State]
Power On By PCIE [Disabled]
[Disabled] 不允許 PCIE 設備喚醒系統。
[Enabled] 允許PCIE 設備喚醒系統。
Power On By RTC [Disabled]
[Disabled] 關閉即時時鐘（RTC）喚醒功能。
[Enabled] 當設置為 [Enabled] 時，RTC Alarm 日期/系統時間可由用戶
自行設置
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
Advanced
Specify what state to go to
when power is re-applied after
a power failure (G3 state).
Restore AC Power Loss [Last State]
Power On By PCIE [Disabled]
Power On By RTC [Disabled]
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
Advanced