User Manual

User Manual

Getting Start

1. Thanks for purchasing this product

This product used the latest wireless 2.4GHz solution and the most advanced optical sensor to detect

the cursor movement, position and rapid. Especially receiver is build-in design for Asus PC system.

2.System Requirement：

IBM PC compatible.

3. Important information

Before you use this product, please read the user manual in this product to avoid and reduce the

operating harm of your wrist.

This receiver is completely meet the international safety requirement. Please use this product from 0

degree to 40 degrees in Celsius (F32-F104 degrees).

Please do not disassemble the receiver yourself or might cause you in danger.

4. Connection

1. Ensure the receiver is tightened on pc system by screws. (H1,H2)

2. Ensure C1 is connected to pc USB interface port.

5. C1 connector Pin Description

Pin No.

Signal Name Type

1. DM I/O USB Bus

2. DP I/O USB Bus

3. GND GND

4. NC Open (N.C.)

5. Vbus 5 V power

PAGE 1
User Manual Getting Start 1. Thanks for purchasing this product This product used the latest wireless 2.4GHz solution and the most advanced optical sensor to detect the cursor movement, position and rapid. Especially receiver is build-in design for Asus PC system. 2.System Requirement： IBM PC compatible. 3. Important information Before you use this product, please read the user manual in this product to avoid and reduce the operating harm of your wrist.
PAGE 2
FEDERAL COMMUNICATIONS COMMISSION (FCC) STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, Pursuant to Part 15 the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
PAGE 3
Canada-Industry Canada (IC) STATEMENT This device complies with RSS-210 of the Industry Canada rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. This device is intended only for OEM integrators under the following conditions: 1)The antenna must be installed such that 20cm is maintained between the antenna and users.