Classification Doc Number Date Version Confidential June 23, 2007 Draft v0.2 E-Tool for EMP U360 Operating Manual ASUSTeK Computer Inc. Mobile Communication Business Unit R&D Div.
E-Tool for EMP U360 Revision History Date Description Old Version New Version 2007/06/01 Draft created V0.1 2007/06/23 Add “Get Slot ID” and “Switch to TP Mode” V0.
E-Tool for EMP U360 Contents 1 Introduction ................................................................................................................................. 3 2 Set Slot ID ................................................................................................................................... 3 3 Switch to TP Mode.................................................................................錯誤 錯誤! 尚未定義書籤。 尚未定義書籤。 錯誤 4 Operating Method ..........................................
E-Tool for EMP U360 1 Introduction This document describes the operating method by using E-Tool for EMP U360. 2 Set Slot ID Step 1 The E-Tool V1.0 dialog box will show when you execute P_E_tool.exe. Step 2 Choose Function->Slot ID, and click it to Set Slot ID automatically. Step 3 It will show the following dialog , click “確定” to continue.
E-Tool for EMP U360 Step 4 It will show the following dialog, turn on inactive DUT ,then click “Abort” to continue. Step 5 If it shows the following dialog , click“確定” and please repeat Step2 through to Step4 . Step 6 If the following dialog appeared , it represents Set Slot ID successfully. 4 Operating Method GSM PART Step 1 The E-Tool V1.0 dialog box will show when you execute P_E_tool.exe.
E-Tool for EMP U360 Step 2 Choose Function->U360->GSM, and click GSM to show GSM_U360_form dialog box. Step 3 Choice com port number to communicate with Mustang.
E-Tool for EMP U360 Step 4 Choice which tp command to send Set GSM Static TX Set GSM Switched TX 6 ASUSTeK Strictly Confidential
E-Tool for EMP U360 Set GSM Static RX Set GSM Switched RX 7 ASUSTeK Strictly Confidential
E-Tool for EMP U360 Reset the GSM Radio Result is showed as below 8 ASUSTeK Strictly Confidential
E-Tool for EMP U360 WCDMA PART Step 1 The E-Tool V1.0 dialog box will show when you execute P_E_tool.exe. Step 2 Choose Finction->U360->WCDMA, and click WCDMA to show WCDMA_U360_form dialog box.
E-Tool for EMP U360 Step 3 Choice com port umber to communicate with Mustang.
E-Tool for EMP U360 Step 4 Choice Band MODE to send the tp command Set WCDMA TX 11 ASUSTeK Strictly Confidential
E-Tool for EMP U360 Set WCDMA RX 12 ASUSTeK Strictly Confidential
E-Tool for EMP U360 POWER Sense ADC Read Result is showed as below 13 ASUSTeK Strictly Confidential
E-Tool for EMP U360 14 ASUSTeK Strictly Confidential
E-Tool for EMP U360 Step 5 Reset WCDMA Radio Compliance with FCC rules and regulation: *The maximum antenna gain allowed for use with this device is 0 dBi.
E-Tool for EMP U360 *When the module is installed in the host device, the FCC ID label must be visible through a window on the final device or it must be visible when an access panel, door or cover is easily removed. If not, a second label must be placed on the outside of the final device that contains the following text: “Contains FCC ID: MSQT 200”.
