User`s manual

Page Page
00:00
:0
0
7:00
7:
7
12:00
FM
AL
iPod
Alarm time
Alarm symbol
Flashing FM symbol
Flashing iPod symbol
Alarm Function
Operational Instructions Operational Instructions
Alarm Time Setting
1. Please make sure the docking station is in “STANDBY” mode.
(LED clock dimmed)
2. Press the button to put the docking station into
“STANDBY” mode (blue backlight dimmed).
3. Press and hold AL-MODE/AL-SET button until the hour
digits on the display are flashing.
4. Press the or button to reach the hour of the desired
WAKE UP time; then press AL-MODE/AL-SET button to
confirm. The display will now show the minute digits flashing.
5. Press the or button to reach the minutes of the desired
WAKE UP time, then press the AL-MODE/AL-SET button to confirm.
6. Select the desired source that the docking station will play at the “WAKE UP” time.:
Press the button to switch on the docking station (display blue light will be “ON”).
1) For iPhone or iPod : Connect the iPhone or iPod to the docking station.
Select the song or the desired playlist to play at the “WAKE UP”
time. Start and pause playback of the song/playlist at the point
from which you want playback to begin at the “WAKE UP” time.
For radio : Tune in the desired station.
For buzzer : No preparation is required.
2) Adjust the volume level as desired by pressing or button. Once the desired
source has been prepared, press the button to put the docking station into standby
mode. Press the AL-MODE/AL-SET button repeatedly to select the source as desired.
The AL(buzz)/iPod/FM lights flash in sequence until the desired source is selected.
7. The alarm time is now fully programmed and the alarm symbol will appear to indicate
that the alarm function is “ACTIVE”.
8. The docking station will now automatically switch “ON” at the wake up time you have
chosen, as long as the alarm function is “ACTIVE”.
9. To turn off the docking station after it has automatically switched on, simply press the
button once. This will switch off the docking station but will not clear the alarm
settings. The docking station will switch on again automatically on the next day at
exactly the same preset time.
10. To deactivate the alarm, press continuously the AL-MODE/AL-SET button until symbol
“AL” disappears from the display.
11. To activate the alarm again, repeat the procedure of “ALARM TIME SETTING”.
coolBlu is equipped with 3 alarm modes: buzzer, radio and iPod. Before setting the alarm,
make sure to set the clock (see “Digital Clock Function” on page 11) .
If the alarm is set to iPod, you need to make certain the iPhone or iPod is connected
properly and using docking station power rather than the battery power of the device.
Otherwise, the buzzer alarm will sound at the set time.
important!
12 13
00:00
:0
0
7:00
7:
7
12:00
FM
AL
iPod
Alarm time
Alarm symbol
Flashing FM symbol
Flashing iPod symbol
3. Hour (Flashing)
4. Minutes (Flashing)
 
MEMORY
AL-MODEFUNC.
EQ
 
MEMORY
AL-MODEFUNC.
EQ
 
MEMORY
AL-MODEFUNC.
EQ
 
MEMORY
AL-MODEFUNC.
EQ
 
MEMORY
AL-MODEFUNC.
EQ
 
MEMORY
AL-MODEFUNC.
EQ
 
MEMORY
AL-MODEFUNC.
EQ
 
MEMORY
AL-MODEFUNC.
EQ
 
MEMORY
AL-MODEFUNC.
EQ
 
MEMORY
AL-MODEFUNC.
EQ