ATAG VA68211TT
Operating Instructions Dishwasher ATAG VA68211TT Dear ATAG customer! We hope that you will have many years of use from your new machine. The machine has many features. To make the most of its functions, we recommend that you read the operating instructions before using the machine. The operating instructions include information on how you can help protect the environment.
Contents Front panel Safety instructions Before washing for the first time Loading the dishwasher Using the dishwasher Settings Care and cleaning Troubleshooting Information for test institute Technical information Installation Service Programme chart Your notes 2 3 4 5 8 11 14 16 19 21 22 23 24 25 Front panel 7 8 1 2 3 4 5 6 9 10 11 12 13 11 14 1 On/Left-on mode 6 TAB (3-in-1/all-in-one detergent) Delayed start 2 Programme selector 7 Salt indicator 12 Set time (for the Time progra
Safety instructions General Winter storage/Transport • Read the operating instructions and keep them in a safe place! • Never use the dishwasher for any purpose other than that specified in these operating instructions. • Do not load the dishwasher door or dishwasher baskets with anything other than dishes. • Never leave the dishwasher door open as someone may trip on it.
Before washing for the first time Programme key Some dishwashers include programme keys in different languages. Attach the programme key in the desired language to the top of the door. Do as follows the first time: 1 Unscrew the lid as illustrated. 2 Place the funnel supplied with the dishwasher in the salt compartment top-up hole. First, pour in about 1 l of water. 3 Then add salt, a maximum of 1.5 kg, until the compartment is full. 4 Wipe up any excess salt so that the lid can be screwed on firmly.
Loading the dishwasher NOTE! Economic dishwashing After topping up, it may take a while before the symbol goes out. Run programmes only with a full load Wait to run a programme until the dishwasher is full, this way you save energy. Use the Rinse & Hold programme to rinse the dishes if there are any unpleasant odours while you wait for the dishwasher to become fully loaded. Setting the rinse aid dosage The section Settings describes how to set the rinse aid dosage.
The dishwasher's baskets The dishwasher is equipped with a top cutlery tray, an upper basket and a lower basket with cutlery basket. The appearance of the baskets may differ depending on the dishwasher setup. Top cutlery tray The top cutlery tray has space for cutlery, ladles, whisks, serving cutlery and similar items. Raising the top cutlery tray 1 Pull out the top cutlery tray. 2 Pull forward the two locking handles on either side to raise the top cutlery tray.
Lower basket a b c Place plates, side plates, serving dishes, pots and cutlery (in the cutlery basket) in the lower basket. Place pots and pans in the rear right part of the lower basket to best utilise dishwashing performance from the rear of the two spray nozzles, which are intended for these types of dishes.
Using the dishwasher Add detergent On/Left-on mode Press and hold the On/Left-on mode button until the display lights up. Programme selection Press the Programme selector one or more times until the desired programme symbol appears on the display. Auto wash The dishwasher can measure how dirty the dishes are and adjust water consumption and temperature accordingly. When newly installed, the programme needs to be run five times before it is fully adapted and can provide the best results.
You can vary the temperature as shown below: Delicate wash If the dishes are not very dirty, you can select Delicate wash. This programme is intended for glasses and porcelain that have just been used and as such do not require such a powerful programme. This programme can be used for fragile dishes. Select Short dry if you want to be especially cautious. See also the section Fragile dishes in Chapter Loading the dishwasher.
Flashing red This indicates a fault. See further in the section Troubleshooting. NOTE! If the machine does not start within 2 minutes of the last button press, the display returns to showing the last programme run. Time remaining Once you have selected a programme and options, the display indicates how long the programme took the last time it was used. The remaining time is updated after the water for the final rinse has been heated.
Settings Do as follows to open the settings menu: + 1. First, open the door. Turn off the dishwasher using the On/Left-on mode button (press and hold). Release the button. 2. Press and hold the On/Left-on mode button until the display lights up. 3. Within five seconds, press and hold the Programme selector and the Long dry button. 4. Release the buttons when the display shows . TIP! Be sure to press right on the symbols, so as not to inadvertently activate any other button.
Button press Options Settings Description Press Start/Stop to save the setting value and continue to the next setting. (Low) LCD contrast For adjusting the contrast of the display on the panel. (High) Press Start/Stop to save the setting value and continue to the next setting. (Off) Rinse aid Rinse aid dosage setting. (Low dosage) (High dosage) Press Start/Stop to save the setting value and continue to the next setting.
Button press Options (Soft water) Settings Description Water hardness Adjusting the water softener. Read off the appropriate setting from the water hardness table below. (Hard water) °dH °fH 0-5 0-9 6-8 10-14 9-11 15-20 12-14 21-25 15-19 26-34 20-24 35-43 25-29 44-52 30-39 53-70 40-49 71-88 50+ 89+ Press Start/Stop to exit the settings menu.
Care and cleaning Coarse filter NOTE! The coarse filter traps larger food particles, which cannot get past the drainage pump. Empty the coarse filter as necessary. The dishwasher must not be used without the filters in place! 1 Lift the coarse filter by the handle. Dishwashing results may be affected if the coarse filter is incorrectly fitted. 2 Empty the coarse filter. Remember to replace it! Drainage pump Coarse filter The pump can be accessed from inside the dishwasher.
Door When cleaning the edge around the door, use only a slightly damp cloth (with a little cleaner if necessary). WARNING! Do not use a spray bottle or the like around the door lock. This is to ensure that water does not penetrate the door catch and come into contact with the electrical components. Lower spray arm • Pull the lower spray arm straight up to release it. Upper spray arm • Pull out the upper basket. • Unscrew the spray arm bearings counterclockwise to remove the spray arm from the upper basket.
Troubleshooting Display Type of fault Action Overfilling Call the service division. Water outlet fault See "Water remains in the dishwasher" in the table below. Water inlet fault Check that the water tap is on. Inlet valve leakage Turn off the water tap and call the service division. Turn off the machine with the On/Left-on mode button and then turn it on again to clear the error message from the display. Problem Possible causes Action The dishes are not clean. The spray arms do not rotate.
Problem Possible causes Action Spots on stainless steel or silver. Some foodstuffs, such as mustard, Rinse off these types of foodstuffs if not mayonnaise, lemon, vinegar, salt and starting the dishwasher immediately. Why dressings, can mark stainless steel if left for not use the Rinse & Hold programme. too long. All stainless steel can cause spots on silver Silver and stainless steel items should not if they come into contact during dishwashing. come into contact during dishwashing.
Problem Possible causes Action The dishes are not dry enough. Drying power too low. Activate the Long dry option. The dishwasher is not fully loaded. Fully load the dishwasher. Rinse aid needs topping up or dosage is set Top up with rinse add or increase the rinse too low. aid dosage. See the sections Before washing for the first time and Settings.
Information for test institute Energy labelling European test standard: EN 60436 Number of standard place settings: 14 Dishwashing programmes: Eco wash, High temperature Connection: Cold water 15 °C Dosages during testing Detergent: In accordance with EN 60436 Rinse aid: In accordance with EN 60436 Prewash: 7.5 gram Rinse aid dosage: 5 Main wash: 27.
Loading the dishwasher See section Energy labelling.
Technical information Information on energy labelling Information sheet, in compliance with Commission Delegated Regulation (EU) No. 1059/2010 ATAG Model designation: VA68211TT Number of standard place settings: 14 1) Energy efficiency class: A++ Annual energy consumption(AEC): 264 kWh per year 2) Energy consumption of the standard cleaning cycle(Et): 0.93 kWh Power consumption Off-mode (Po): 0.49 W Left-on mode (Pl): 0.
1189 596 573 550 550 519 [mm] 133-183 670 700 824 -872 680-760 377 444 195 54 Installation 49 30 30-94 *Remove locking nuts and any coasters for an installed height of 820-824 mm. **Door length. It is important that you read through and follow the instructions and directions below. Conduct installation and connection in accordance with the separate installation instructions. Safety instructions • Connections to electricity, water and drainage must be performed by a qualified professional.
Service Once the installation is complete, the stopcock should be opened to allow the pressure to settle for a while and to check that all connections are tight. Connect to cold water... If you use oil or electricity to heat your home. Connect to hot water (max. 70 °C)... If you use district heating, solar power or geothermal power to heat your home. Choosing a hot water connection cuts programme times and reduces the dishwasher's electricity consumption.
24 2 2 1 Heavy wash Normal wash Daily wash 1 1 1 Eco wash 4) Upper half Lower half 3 14 14 9.45 14 10 10 13 18 19 This dishwashing programme is the standard cleaning cycle used to compile the energy labelling information. It is intended for washing normally dirty dishes and is the most effective programme in terms of combined energy and water consumption. 0.01 0.6 0.6 0.7 0.5 0.9 0.1 0.7 0.8 1.0 11-19 Connection to hot water, approx. 60 °C.
Your notes 25
Your notes 26
Your notes 27
Quick guide Load the baskets 1. (See page 5.) Do not rinse dishes under running water before loading them in the dishwasher. Simply scrape off large food particles before loading the dishwasher. Check that the spray arms can rotate freely 2. Check also that the water tap is on. Add detergent 3. 4. The detergent compartment has one smaller compartment for the prewash and one for the main wash. (See page 8.
en (01-15)