ATD-30330 30” PEDESTAL FAN INSTRUCTIONS Item No. Blade Diameter Voltage / Hz Current (A) ATD-30330 30” 120V /60Hz 1.4 READ AND SAVE THESE INSTRUCTIONS Failure to properly follow these instructions may lead to injury or bodily harm.
California Prop 65 WARNING: This product contains chemicals including lead, known to the State of California to cause cancer, birth defects, or other reproductive harm. Wash hands after handling. General Safety Warnings: WARNING: The instructions and warnings contained in this manual should be read and understood before using or operating this fan. Do not allow anyone to use or operate this fan until they have read this manual and have developed a thorough understanding of how this fan works.
WARNING: Never use the cord for carrying, pulling or unplugging the fan. Grasp plug and pull to disconnect from outlet. Keep cord away from heat, oil, sharp edges or moving parts. Replace damaged cords immediately. WARNING: Ensure the switch is in the off position before plugging the fan into the power outlet. In the event of a power failure while the fan is being used, turn the switch off to prevent surprise starting when the power is restored.
Assembly Instructions: 1. Connect the lower pole (8) to the base (10) with fasteners (9) 2. Insert the upper adjustable pole (7) into lower pole (8), then adjust it to the height you want by tightening the knob. In the future, you can adjust fan height by loosening & tightening this knob. PLEASE NOTE THAT ADJUSTABLE SPRING MUST BE PUT INSIDE OF LOWER POLE (8) 3. Mount the motor (5) on upper adjustable pole (7) affix with fasteners (6) 4. Connect the rear guard (4) to motor (5) with washers and nuts. 5.
ATD-30330 ITEM# 1 2 3 4 5 6 7 8 9 ORDERING PART# PART DESCRIPTION PRT30330-01 FRONT GUARD PRT30330-02 BLADE PRT30330-03 REAR GUARD PRT30330-04 MOTOR PRT30330-05 HEIGHT ADJUSTING POLE PRT30330-06 SPRING PRT30330-07 STANDING POLE PRT30330-08 BASE PRT30330-09 WHEELS Please contact jay@supertestusa.com for parts and service issues Made in China to ATD Tools, Visit us at www.atdtools.