User's Manual

5.Maintanceandinspection
1) Thearmatureandstator (motor) isthe heartof thepower tool. Exercisedue caretoensurethey donot
becomedamagedoraffectedbyoilorwater.
2) Inspectthecarbonbrushesregularlyandreplacewhentheyarewornupaboutonethird.
3) Regularly inspect all mountings and
 screws and ensure they are properly tightened. Showed any of the
screwsbeloose,tightenthemimmediately.Failuretodosomayresultinseriousdamage.
4) The supply cord of the tool and any extension cord used should be checked frequently for damage. If
damaged, have the cord set
replaced by an authorized service facility. Replace the extension cord if
necessary.
5) The grease in the gearbox will require replacement after extensive use of the tool. Please refer to an 
authorizedserviceagenttoprovidethisservice.
6) Consultanauthorizedserviceagentintheeventoffailure.
7) Clean
anddustthetoolaftereachuse.


6.Accessories

CAUTION:Theseaccessoriesorattachmentsarerecommendedforusewithyourtoolspecifiedinthismanual.
Theuseofanyotheraccessoriesorattachmentsmightpresentariskofinjurytopersons.Onlyuseaccessory
orattachmentforitsstatedpurpose.

Auxiliaryhandle1pc
Spanner1pc
InnerHex.Spanner1pc

GrindingWheel1pc 






















