Owner’s Manual Engine Crane Model Number ATD-10141 Capacity 2 Ton Atd Tools Inc.
Save these instructions. For your safety, read, understand, and follow the information provided with and on this jack. The owner and operator of this equipment shall have an understanding of this engine crane and safe operating procedures before attempting to use. The owner and operator shall be aware that use and repair of this product may require special skills and knowledge. Instructions and safety information shall be conveyed in the operator's native language before use of this jack is authorized.
ASSEMBLY 1. Attach two front casters (#1) to legs (# 3) with M8x12 bolts (# 2). 2. Attach two middle casters (#6) and two rear casters (#1) to base (#4) with M8x12 bolts (#2). 3. Slide two legs (#3) into the base (#4) and secure with M14x30 bolts (#8). 4. Attach upright (#7) to base (#4) with M14x100 bolts (#9), washers (#10) and nuts (#11). 5. Attach two strut supports (#12) to base (#4) and upright (#7) with M16x100 bolts (#13), washers (#14), and nuts (#15). 6.
BEFORE USE OPERATION 1. Inspect crane before each use. Do not use if bent, broken or cracked components are noted. Ensure that casters/wheels and boom move freely. Check for and tighten any loose assemblies. 2. Verify that the product and the application are compatible. 3. Before using this product, read the owner's manual completely and familiarize yourself thoroughly with the product and the hazards associated with its improper use.
MAINTENANCE Important: Use only a good grade hydraulic jack oil. Avoid mixing different types of fluid and NEVER use brake fluid, turbine oil, transmission fluid, motor oil or glycerin. Improper fluid can cause failure of the jack and the potential for sudden and immediate loss of load. We recommend Mobil 13M or equivalent. Lubrication A periodic coating of light lubricating oil to pivot points, axles and hinges will help to prevent rust and assure that wheels, casters, and pump assemblies move freely.
TROUBLESHOOTING Symptom Possible Causes Corrective Action Jack will not lift load • Release valve not tightly closed • Overload condition • Ensure release valve tightly closed • Remedy overload condition Jack *bleeds off after lift • Release valve not tightly closed • Overload condition • Hydraulic unit malfunction • Ensure release valve tightly closed • Remedy overload condition • Replace hydraulic unit • Reservoir overfilled • Drain fluid to proper level Poor lift performance • Fluid level low
REPLACEMENT PARTS Not all components of the crane are replacement items, but are illustrated as a convenient reference of location and position in the assembly sequence. When ordering parts, give the model number, serial number and parts description.
ONE YEAR LIMITED WARRANTY For a period of one (1) year from date of purchase, Atd Tools Inc. will repair or replace, at its option, without charge, any of its products which fails due to a defect in material or workmanship, or which fails to conform to any implied warranty not excluded hereby. Performance of any obligation under this warranty may be obtained by contacting your point of sale and obtaining return or repair information from your supplier.
