User's Manual

Figure 2 - Assembly Illustration for Model ATD-10141

ASSEMBLY

1. Attach two front casters (#1) to legs (# 3) with M8x12 bolts (# 2).

2. Attach two middle casters (#6) and two rear casters (#1) to base (#4) with M8x12 bolts (#2).

3. Slide two legs (#3) into the base (#4) and secure with M14x30 bolts (#8).

4. Attach upright (#7) to base (#4) with M14x100 bolts (#9), washers (#10) and nuts (#11).

5. Attach two strut supports (#12) to base (#4) and upright (#7) with M16x100 bolts (#13), washers (#14), and nuts

(#15).

6. Place hydraulic unit (#16) on upright’s support bracket and secure with M16 x 90 bolt (#17), washer (#18) and nut

(#19).

7. Attach boom (#20) to upright (#7) with M20x100 bolt (#21), washer (#22), and nut (#23).

8. Pump jack until ram is extended approximately 2”.

9. Allign the hole on the hydraulic ram with the mounting hole of boom and secure with the lock pin (#24) and retainer

clip (#25).

10. Slide boom extension (#26) into boom (#20) and secure with the lock pin (#24) and retainer clip (# 25).

11. Attach chain/hook assembly (#30) to boom extension (#26) with M14x80 bolt (#27), washer (#28) and nut (#29).

12. Attach handle to upright with four M8x12 bolts (#31).