Assembly Instructions

Page 1 of 3

Adult Assembly

ASSEMBLY INSTRUCTIONS

Before assembling your Printer stand, please read through these

instructions carefully and familiarize yourself with the different parts.

MISSION PRINTER STAND CHARGING STATION

Hexagon Wrench

Flat washer - 8 pcs Wooden Dowel 3/8 X 1 1/4” - 4 pcs

Wooden Dowel 1/4” X 1 1/4” - 4 pcs

Spare - 2 pcs

Spare - 1 pc

Hexagon nut - 8 pcs Wood Screw - 6 pcs

Spare - 2 pcs

Spare - 1 pc

Hexagon wrench - 1 pc

NOTE: WE INCLUDE SPARE HARDWARE IN CASE THE HEXAGON NUT, WASHER, WOODEN DOWEL,

OR WOOD SCREW ARE DAMAGED DURING ASSEMBLY.

PARTS LIST

TOP PANEL 1 PC

4 PCS

2 PCS

1 PC

LEG

SIDE PANEL

LOWER SHELF

ATTENTION! If you receive a damaged or defective item,

please contact Atlantic Furniture at service@atlanticfurniture.com 1-800-955-3726 / M-F 9:00-5:00 EST

READY

ASSEMBLE

PAGE 1
MISSION PRINTER STAND CHARGING STATION ASSEMBLY INSTRUCTIONS READY TO Before assembling your Printer stand, please read through these ASSEMBLE instructions carefully and familiarize yourself with the different parts. ATTENTION! If you receive a damaged or defective item, please contact Atlantic Furniture at service@atlanticfurniture.
PAGE 2
STEP 1 Attach the legs (02) to the top panel (01) using flat washers (A) and hexagon nuts (B), tighten with hexagon wrench (C), as shown below. 02 A B 02 A 02 Adult Assembly 02 B 02 01 A B B A STEP 2 STEP 3 Attach first side panel (03) to printer stand aligning the dowels (D) with the holes in the apron. Be sure the panel is centered before tightening the wood screw (F). Install wooden dowels (D) and (E) into the locator holes on (03) and (04) as shown below.
PAGE 3
STEP 4 Attach second side panel (03) the same as the first but place the lower shelf (04) in position by aligning the wooden dowels (E) with the holes in the side panel. E 04 E 03 Adult Assembly STEP 5 Apply presure to eliminate any gap between the lower shelf and the side panel and fix in place using wood screw (F). Adult Assembly F F F F F Congratulations! Your Printer stand is now ready for use.