Instruction manual








Very little excess water should accumulate. During the process
of cooling, some of the water accumulated is actually used to
cool the unit internally, making it run more efficiently. Both this
evaporative technology and Innovative AutoDrain NanoMist
Technology™ are features not found in most portable air
conditioners.
To empty the water container do the following:
• Switch off the unit and remove the plug from the wall socket.


• Place the water container on the floor underneath the
permanent drainage point.
• Remove the water stopper and rubber plug from the drain and let the water run
out. The water container has to be emptied several times before all water will be
drained (ca. 1.5 litres).
• Replace the rubber plug and water stopper, put the plug into the wall socket, and
switch the unit on. The warning signal should be off.
NOTE!
• Remove the 3M™ High Air Flow lter and active carbon lter before seasonal
storage and install new lters at the beginning of the new season. The old lters can
be disposed in the ‘Non-biological garbage container’.
• Replacement lter packages are available directly from Atlantic.
• To run the unit without active carbon lter and/or 3M™ High Air Flow lter does not
do any harm to the air conditioner. In this case odours and unhealthy dust are not
removed from the circulated air.
• The screen lter must always be used.
• 3M™ is a trademark of the 3M Company.