Instruction manual
Press to switch the unit on, or to switch off. A buzzer will beep, and the LCD will
display 12:00 o’clock as default.
Press the -button for 3 seconds to set the clock. The 2 left digits of the 4 digits on
the LCD-display will flash. Press or to adjust the hour. Press momentarily,
the 2 right digits of the 4 digits will flash. Press or to adjust the minutes of the
clock. Press the -button for 3 seconds again to activate the clock.
If you want to change the set temperature press the or -button. The 2 digit
display will indicate the set temperature.
Reaching the set temperature depends on the room and outdoor climatic
conditions.
Pressing the -button successively until the icon representing the desired mode is
appearing
(=> Cool => Fan => Heat => etc). On the LCD-display you will see:
Cooling Fan only Heat
Each time the unit starts, it starts operating in cool mode with a set temperature of
22°C. The fan speed will be selected automatically.
If you prefer a constant fan speed instead of the auto fan speed, press the -button
successively; the fan speed icon on the LCD-display will rotate accordingly.
• Fast - for the turbo speed
• Normal - for the medium speed
• Slow - for the slow speed
• Auto - alternating fast and slow speed
With the mode switch select , set the desired temperature and the unit will heat
until this temperature is reached. Fan speed is selected automatically. Do not place
the unit near anything that could catch fire or be scorched. Do not
obstruct the air outlet.
For all of the following TIMER programming, proceed firstly with
these standard steps:
• Press the -button briefly; the 2 left digits of the 4 digits on the
Timer example