Instructions / Assembly

8
Figure 14
Figure 13
9. PROGRAMMING YOUR
FAN AND OPERATING
THE REMOTE CONTROL
Your DC brushless motor is equipped with a
automatically learned type remote control.
Before programming takes place, fan must be
fully assembled and mounted to the ceiling with
blades attached.
Install one 23A/12V battery (included). To prevent
damage to transmitter, remove the battery if not
used for long periods of time (Fig. 13)
ON ECE
1234
Restore power to ceiling fan and test for proper
operation.
A. I, II, III, IV, V and VI button:
These six buttons are used to set the fan speed as
follows:
I = minimum speed
II = low speed
III = medium low speed
IV = medium speed
V = medium high speed
VI = high speed
B. button:
This button turns the fan off.
C. Reverse button:
This button is to control fan direction
D. SET code setting button:
Follow the below steps to set the remote control:
The auto learning function will only mandate within
60 seconds when turning the fan’s AC power ON.
a) Select desired frequency from the back of
transmitter.
b) From the back of the transmitter, press the “SET”
button, and hold the “SET” button for over 10
seconds. Once the receiver has detected the
frequency, the light will flash twice, and the fan will
automatically begin to operate and start to rotate in
the counterclockwise direction and on the highest
RPM for 3 minutes. When counterclockwise rotation
has finished, the fan will automatically reverse to
clockwise direction again to the highest RPM for 3
minutes. Fan will shut off when the self calibration
test has finished. The total self calibration test will
last about 6 minutes.
NOTE: If the self calibration test failed, turn the AC
power off; restore power and process the self
calibration test again.