VGA & Stereo Audio CAT5 Extender With Chainable Output models: AT-2VGA300SL, AT-4VGA300SL, AT-VGA300RL AT-2VGA300SL AT-VGA300RL AT-4VGA300SL User Manual Toll free: 1-877-536-3976 Local: 1-408-962-0515 www.atlona.
TABLE OF CONTENTS 1. Introduction 2 2. Specifications 3 3. Panel View 4 4. Switch Settings 4 5. Connection and Installation 5 6. Safety Information 7 7. Warranty 8 8. Atlona Product Registration Toll free: 1-877-536-3976 Local: 1-408-962-0515 9 1 www.atlona.
INTRODUCTION AT-2VGA300SL, AT-4VGA300SL (sender units ) are designed to transfer VGA & Stereo Audio signal over cost effective CAT5 cable. AT-VGA300RL ( receiver unit ) has built in chainable output to cascade the other receiver for working range over 1000ft (300 meters). This AV Extender is the smart, fast and cost-effective solution, eliminating costly and bulky VGA and Audio cables for the most efficient way to move multimedia content from player to display.
SPECIFICATIONS ITEM NO. AT-2VGA300SL Resolution AT-4VGA300SL Up to 1600 x 1200 Video Bandwidth Sender 750MHz / Receiver 350MHz-3db Video Input / Output RGB Analog, 75Ω, 0.7Vp-p Sync Input / Output H/V Separated, 5V TTL Horizontal Frequency 30-95 KHz Vertical Frequency 50-180 Hz VGA Connector 15-pin Mini D-Sub (High Density) Analog Audio Input / Output 10KΩ, 3Vp-p (Max) Analog Audio Bandwidth 20-20KHz-3dB Analog Audio Connector 3.
PANEL VIEW AT-2VGA300SL AT-4VGA300SL AT-VGA300RL SWITCH SETTINGS DIP Switcher Setting: 1 2 setup built in DDC (1280x1024@75Hz Max) setup DDC of local monitor setup DDC backup of local monitor backup DDC of local monitor AT-2VGA300SL LED: Blue (front panel): power on/off RJ45 LE D (Link cable connector) : Yellow LE D status indication: No light: Normal Light: Waiting local Monitor connection (duplication DDC mode) Blink one time: Finish DDC backup (duplication DDC mode) Blink two times: Monitor DDC
Blink three times: Blink four times: Blink five times: Blink six times: DDC check sum error Memory read error Memory writes error Memory verify error AT-2VGA300SL/AT-4VGA300SL Duplicate DDC step: 1. Dip switch 1 & 2 at “down” position, if the Sender already connected to the local monitor; please jump to the third step. 2. If Sender has not connected with local monitor yet, the yellow LED will keep lit to wait local monitor connection. 3.
Installation Tips: 1. Due to the inside of CAT5 cable containing pairs of wires twisted at different rates, and the different quality on the cable itself and installation, different signal arrival time may occur at eachpair. If there is a big difference at arrival time, that will cause RGB skew status.This is seen onthe monitor as separation, or lack of convergence in colors. Normally it happens on long CAT 5 cable runs. 2.
SAFETY INFORMATION Safeguards To reduce the risk of electric shock, do not expose this product to rain or moisture If the wall plug does not fit into your local power socket, hire an electrician to replace your obsolete socket. Do not modify the wall plug. Doing so will void the warranty and safety features. This equipment should be installed near the socket outlet and the device should be easily accessible in the case it requires disconnection.
WARRANTY Limited Warranty Atlona Technologies warrants that (a) its products (AT-2VGA300SL, AT-4VGA300SL or AT-VGA300RL) will perform substantially in accordance with the accompanying written materials for a period of 3 years from the date of receipt and (b) that the product will be free from defects in materials and workmanship under normal use and service for a period of 3 years.
ATLONA PRODUCT REGISTRATION Thank you for purchasing this Atlona product. - We hope you enjoy it and will take an extra few moments to register your new purchase. Registration creates an ownership record if your product is lost or stolen and helps ensure you’ll receive notification of performance issues and firmware updates. At Atlona, we respect and protect your privacy, assuring you that your registration information is completely secure.